primary winding

英 [ˈpraɪməri ˈwɪndɪŋ]

美 [ˈpraɪmeri ˈwɪndɪŋ]

一次绕组；原绕组

电力

英英释义

noun

• coil forming the part of an electrical circuit such that changing current in it induces a current in a neighboring circuit
  1. current through the primary coil induces current in the secondary coil
  Synonym:primary coilprimary

双语例句

• The unbalanced degrees of current in primary winding under different load conditions are discussed, which are based on the general expressions of negative phase sequence current.
  结合负序电流的通用表达式，讨论了在不同负荷条件下的原边电流不平衡度。
• The influence between Section spacing of secondary winding, primary winding and flux leakage of magnetic core to the secondary winding are simulated, the equivalent factor is introduced between the rectangular wire and the round wire.
  模拟分析次级绕组段间距、初级绕组以及磁芯漏磁对次级绕组损耗的影响，并引入了矩形导线和圆导线之间的等效因子。
• A new way to measure the conducted electromagnetic interference, which regards the IGBT of injected port of primary winding in automobile port fire as a power supply working in switch model, has been provided.
  提出了一种把汽车点火系统的初级线圈电压注入端的绝缘闸双极性晶体管（IGBT）作为一种开关模式电源并对其工作时产生的传导干扰进行测量。
• If the primary current of the transformer flows into the dotted end of the primary winding, the sencondary current will flow out of the dotted end of the secondary winding.
  如果电流从变压器的原边有标记端流入，则副边的电流从有标记端流出。
• The inductance of primary winding, secondary winding and the mutual inductance between two windings of the models are calculated by solving the 3D magnetostatic field in the models.
  通过计算带抽能线圈并联电抗器模型的三维静磁场，得到带抽能线圈并联电抗器模型的一次、二次线圈的电感和互感等参数。
• With consideration of ST's insulation and volume, the parameter of ST was determined by the theory analysis and computation of the primary winding.
  通过对初级绕组的计算分析及考虑体积、绝缘的基础上，确定了ST的相关参数。
• The electronic control unit allows current to flow through the ignition coil primary winding until it senses a triggering voltage pulse from the speed sensor, or pickup coil.
  电子控制单元使电流通过初级绕组直到感知到一个从转速传感器或拾波线圈产生的触发电压脉冲。
• The transformer adopts multiple secondary compensation winding structure. The primary winding is in parallel with the harmonic load and the secondary compensation windings are connected with PWM inverters.
  变压器采用副方多补偿绕组结构，原方绕组与谐波负载相并联，副方补偿绕组分别与逆变器相联。
• And finally, on the basis of the magnetic integration, the application of passive integration technology, through staggered parallel structure in the primary winding of transformer in the integrated resonant capacitor, through the Maxwell 2D simulation software to validate the correctness of the design.
  最后，在平面磁集成结构的基础上，应用无源集成技术，通过交错并联结构在变压器原边中集成谐振电容，并通过Maxwell2D仿真软件验证设计的正确性。
• The distribution of the third harmonic magnetic field in imported large rectifier transformer is analyzed. The reason of conductor damage in winding is discussed. The overheat possibility in primary winding is expounded.
  分析了进口大型整流变压器三次谐波磁场的分布，讨论了绕组导体绝缘损坏的原因，一次绕组存在过热的可能性，提出了可采取的改进措施。